How To Change Rear Wiper Blade On 2013 Toyota Sienna

Toyota Sienna Rear Window Wiper Blade Replacement Guide
How to change the rear windshield window wiper bract on a 3rd generation 2011 to 2016 Toyota Sienna minivan.

Wiper Arm In Down Position
Raise Wiper Arm Off Window This automotive maintenance tutorial was specifically written to assist owners of the third generation (2011, 2012, 2013, 2014 and also the updated 2015 & 2016 model years) Toyota Sienna minivan in changing the rear windshield window wiper bract.

Owners of other Toyota vehicles with a similar rear window wiper such as the FJ Cruiser, Venza, Highlander, 4Runner, Sequoia, RAV4 and Country Cruiser, may also find these DIY instructions to be helpful.

The original OEM rear window wiper bract size in inches is 16" long.

Some compatible replacement new aftermarket xvi" blades with their part numbers are as follows: Trico xvi-A, Anco AR-16A, Bosch H409, Michelin 9516, Toyota 85242-08020 and Rain-X R16A.

No tools are needed to supercede the rear wiper blade.

Rotate Bract Away From Arm
Pop Bract Out of Subclass The offset few steps are to sit down in the driver's seat, turn the ignition key to the "On" (accessory) position, merely do not start the engine, and activate the rear window wiper.

Spotter the wiper in the rear view mirror and when you meet the wiper arm facing straight downward, speedily plow the ignition fundamental to the "Off" position.

Move to the exterior of the rear window and gently elevator the wiper arm off the window.

Rotate the wiper blade away from the wiper arm until it is almost perpendicular.

Gently pop the mounting bar in the center of the wiper blade out of the "C" shaped socket at the terminate of the wiper arm.

Wiper Arm On Rear Window
Line Up Wiper Mountain Bar & "C" Socket Gently rest the wiper arm down on the window. The plastic arm shouldn't cause whatsoever damage to the glass, just you may choose to place a towel betwixt them to protect the window.

I recommend ownership the genuine OEM Toyota 85242-08020 rear wiper bract.

Line upwards the mounting bar in the centre of the new wiper blade with the "C" hinge socket at the end of the wiper arm.

Popular New Blade On Arm
Rotate New Blade Parallel Concord the new wiper blade at almost a perpendicular angle to the wiper arm.

Gently pop the mounting bar in the middle of the blade in to the "C" socket at the cease of the wiper arm.

Then rotate the new bract until information technology is flush (parallel) against the wiper arm. Make sure that the new blade is securely attached to the wiper arm.

Lower Arm To Window
Wiper Arm Retracted Lower the wiper arm associates down to the rear window.

Movement to the driver's seat, plow the ignition to on, and allow the wiper arm to return to information technology's resting position at the top of the window.

It would be a adept idea to thoroughly clean the rear window at this time for optimum wiper performance. I as well recommend applying a glass treatment product that will repel water such as Rain-10.

For more, delight cheque out my other Toyota Sienna Repair & Maintenance Guides.